How to use machine stretch warp film

Once you have chosen the right type of machine film and understand containment force, use the following quick tips to get the most secure wrap

1.Anytime you’re adjusting the machine wrapper for a new load, make sure to start with the wrap arm speed or turntable. Then work up to a suitable speed your pallet can handle. Failure to do so may result in you restacking loads that have fallen.

2.Next set the bottom and top wrap counts and the film overwrap at the top of the load. Start with “2” for the bottom and “2” for the top counts.

3.Then adjust the film delivery system down and up speed. Unless the owner’s manual suggests, you can start with approximately 6 inches overlap of film bands.

4.Lastly, you can adjust the wrap force. The goal is to apply as much force as possible without twisting the load, crushing the load, or breaking the film

Once wrapped, you can measure the containment force at the bottom, middle, and top of the load with your measurement tool. You should adjust the settings and repeat the previous steps until you get the desired containment force.